Logically I would think it shouldn’t, because I’d assume the pod would get flooded and so would the seed… Bit just an assumption,I’m new at this, so my opinion doesn’t really matter!
I measured with a tape, from the bottom side of the top cover there’s approximately 3 1/4" until you reach the water. I could obviously see my pod was in the water so I gently squeezed it up just short of an inch. That’s why you’ll notice in my pic my pod sticks up from the top part of the cover, I was sure the pod sat flush, from now on I’ll measure. I even have an additional pod that’s even longer than this one. Measuring tape is key I think? Hi
That is correct it should NOT be touching the water. It should be suspended slightly above the water. You’re correct @dukz009, you run a significant risk of damping off with it touching.
That’ll work, good job
Thanks dude! Much appreciated!
Hey Russ, for my first grow I decided to go with “Bomb seeds” out of Amsterdam. It’s called auto bomb. I know it’s a quickie but I wanted to do a quick test run before I get into more serious seeds.
Cool I’ve got a couple little ladies from Bomb Seeds ready to go outside
THC Bomb And Cluster Bomb
I’m hoping to try the cluster Bomb in the grobo sometime later in the year - it seems like it might be interesting in the grobo with the short spacing between nodes
Nice! They’ll be good looking plants for sure, I got an “atomic bomb” seed as a freebie but there’s no recipe…
No worries about the lack of recipe @dukz009 there are generic recipes for indica, sativa, autos, and so on that will work just fine. The more of these threads you read the clearer it becomes that the recipes are essentially loose guidelines. You’ll need to watch your plant to figure out what she needs as far as resolving issues and growth stage timing. Also, we have the HUGE added advantage of having a bunch of pro-growers here on AG that are happy to advise on what to do and when to do it!
It won’t happen overnight but just make sure to request the recipe if you already haven’t, and might as well do the other one you had there too so that when you do go to pop that one the recipe is already there. You can just start it on the generic recipe like @SWSVIC has pointed out. I believe you get notified once your recipe is added. Or I’ve just fabricated this, but for some reason I think you do …anyway lol what you can do is mid grow just end your “generic” and then pick your specific one and just push to roughly what stage you were in previously. If it sounds complicated it really isn’t, it’s quite the opposite actually, so when the time comes if you need help just reach out to the fellow champs or community, someone will point you in the right direction
That’s awesome dude, I did not know this!
She’s started! My wife determined the plant will be a she. Thanks for the germination help guys, you guys rock! I’ll keep updating.
Where would one put in a request for a recipe?
(Does this sight take you to your [LightSettings]):?
(20 Hrs. is what you’ll see for [Germination] [EarlyVeg.] [LateVeg.]):
(12 Hrs. is what you’ll see for [Transition] [Flower]):
(So Yes [18 Hrs] would be for an [Auto] Plant):
(I cropped the photo above): (#RequestRecipe):
I know where to find the recipes and so fourth from the list, I meant requesting a new recipe of a seed that’s not in the list. I know @SWSVIC had mentioned they are default settings for the 3 types of cannabis, I think I’ll give that a go on the next run.
It’s right under where you can search for a recipe @dukz009. You have to click on the request link
@Russel_Richardson Thanks Russ, found it!